1 d

For example, if the fill?

t of thread automatically. ?

Remove the thread feeder front cover, carefully using your fingernails or a screwdriver. If this is not done the needle will get blunted (a mushroomed point) quickly due to the excessive thread tension which causes the needle to deflect into the hook basket metal. Check the material thickness and adjust if set too high or too low. Note that the values given for tension are specific to the EMT16X. 1. pghlistcrawler 1) Make sure the thread is seated in the rollers, not under them. Reset thread tension, tails etc to default Set it to auto-feed. Make sure the thread is to the right of the take-up lever. This leads to rough spots and nicks on the rubber belt, which will catch thread and pull it inside through the cover, causing birdnesting inside the thread feeder. 1) Make sure the thread is seated in the rollers, not under them. delta products How to set up for success embroidering Richardson 112 caps on the Melco EMT16X. Press the black tab on the red pinch roller down. The thread tension test tests for upper and bobbin tension. To check the tension of the bobbin, hold the bobbin thread with one hand. As you gently bounce the thread, the bobbin case should drop approximately 1 - 2 inches / 25 - 50 mm. posttome E16 Operator and Parts Manuals, Support Articles, Software Downloads Melco Certified Technicians On that rare occasion when you find yourself in need of a technician to get your machine back up and running, Melco has a long list of certified technicians ready to help. ….

Post Opinion